This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: Checking head and block for warpage?
| Posted By: | Joshua |
| Posted On: | January 15, 2003 at 08:36 am GMST |
85GTSConvert wrote:
> How can I check if my head is
> warped? How about the block? T
> he Haynes manual says to get a
> straight edge and a feeler ga
> uge to do this. What are the t
> olerances?
The Maximum head surface warpage is 0.15mm(0.0059in)
The Maximum manifold surface warpage is 0.20mm(0.0079in)both I believe) That out of the Toyota Repair Manual
The Maximum Block warpage is 0.002in and that out of the Haynes Manual second page of Ch2 partB
Hope this helps
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2002 Steven Benner. All rights reserved.
Last Modified: Tuesday, August 27, 2002 2:48 PM