This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: wtf is this thing?
| Posted By: | Byron |
| Posted On: | July 01, 2003 at 01:02 am GMST |
I think he's refering to the little screw in plastic valves (BVSV???) on the front of the intake manifold. They screw into coolant passage where EFI coolant temp sensor and Cold Start Injector time switch is. There's two vacuum lines that hook to it. One goes to the charcoal canister and other to the throttle body. I don't know what these are for, but they prob monitor vacuum in that specific line since they are screwed into coolant passage.
autozone_mike wrote:
> when i was replacing my tps wh
> ere two hoses hook to the thr
> otel body and run below the tp
> s there is somethign there the
> hoses hook to it broke lookes
> like one hose ran from thrott
> el body to it and the other ra
> n out of it over to the ball/e
> vap canister on the drivers si
> de fender ne1 got a clue what
> this is a sensor or what?
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2003 Steven Benner. All rights reserved.
Last Modified: Wednesday, March 19, 2003 9:00 AM