1983 Toyota Celica GT-S - Message Forum (Re: What the hell is going on?)

Forum

Home

This is an archived message.
The reply function is disabled.

[ Message Forum | Thread Index | Post a Reply ]

Re: What the hell is going on?

Posted By:	buz
Posted On:	August 11, 2003 at 06:45 am GMST

the timing chain puts a hole in the cover once the guide is gone and it stretches
then coolant leaks into the oil
i'd cut the head gasket off flush at the block and use sealant
otherwise it will leak
and after many miles the whole front of your motor will be a greasy dirt spot

Evan wrote:

> yeah thats what I was thinking
> .....all the gaskets are new..
> ..and the water pump is new...
> ...except when I was putting i
> t on...its sorta.....seized...
> .so....and I had to sorta pull
> on it to loosen it up....so..
> ..thats all I can think of...I
> ll take it off tomorrow and se
> e whats going on....I can do i
> t without completely taking th
> e head off right? the head gas
> ket is brand new so it shouldn
> t leak bad when I put the timi
> ng over on..right?
>
>
> buz wrote:
>
> > timing cover?
> >
> >
> > Evan wrote:
> >
> > > Ok.....over the last 5 mon
> th
> > s
> > > Ive swapped the block....s
> wa
> > pp
> > > ed the head.....all new ga
> sk
> > et
> > > s everywhere........and it
> i
> > s
> > > STILL pouring coolant stra
> ig
> > ht
> > > into the oilpan.......what
> t
> > h
> > > e hell is the problem????

Replys:

Re: What the hell is going on? - Evan 08/11/03 (0)

Post a Reply:

Name:
Email:
Subject:
Message:	buz wrote: > the timing chain puts a hole i > n the cover once the guide is > gone and it stretches > then coolant leaks into the oi > l > i'd cut the head gasket off fl > ush at the block and use seala > nt > otherwise it will leak > and after many miles the whole > front of your motor will be a > greasy dirt spot > > > Evan wrote: > > > yeah thats what I was thinki > ng > > .....all the gaskets are new > .. > > ..and the water pump is new. > .. > > ...except when I was putting > i > > t on...its sorta.....seized. > .. > > .so....and I had to sorta pu > ll > > on it to loosen it up....so. > . > > ..thats all I can think of.. > .I > > ll take it off tomorrow and > se > > e whats going on....I can do > i > > t without completely taking > th > > e head off right? the head g > as > > ket is brand new so it shoul > dn > > t leak bad when I put the ti > mi > > ng over on..right? > > > > > > buz wrote: > > > > > timing cover? > > > > > > > > > Evan wrote: > > > > > > > Ok.....over the last 5 m > on > > th > > > s > > > > Ive swapped the block... > .s > > wa > > > pp > > > > ed the head.....all new > ga > > sk > > > et > > > > s everywhere........and > it > > i > > > s > > > > STILL pouring coolant st > ra > > ig > > > ht > > > > into the oilpan.......wh > at > > t > > > h > > > > e hell is the problem??? > ?
	Please click submit only once

Note: For security reasons your IP will be logged!