This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: EFI problems?
| Posted By: | Joshua S |
| Posted On: | August 27, 2003 at 12:20 am GMST |
Evan: you stated that you get a signal form the injector plug connectors Right?
When you check for signal, did you use a analog multi meter(has a pointer) or a digitial multi meter(LCD display)?
What was the voltage you were recoding?
Did you check the front two injector connectors to compare reading?
Have you check the Resistance of each injector?
Have you checked the fuel rail for a block? very unlikely but what else have you to check right?
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2003 Steven Benner. All rights reserved.
Last Modified: Wednesday, March 19, 2003 9:00 AM