1983 Toyota Celica GT-S - Message Forum (Re: engine will not start 22r-ec engine)

Forum

Home

This is an archived message.
The reply function is disabled.

[ Message Forum | Thread Index | Post a Reply ]

Re: engine will not start 22r-ec engine

Posted By:	buz
Posted On:	August 28, 2003 at 04:00 am GMST

not enuf compression
tell me you honed it
otherwise you'll haf to
unless you put the rings in wrong

chris wrote:

> I have a 85 celica gts. We bou
> ght it for $200. they tried to
> replace head gasket but did i
> t wrong. I have gone through a
> nd re done the head gasket. in
> the process i got the head re
> surfaced and a valve job. Whil
> e i was at it i replaced pisto
> n rings and rod bearings. I be
> lieve i did all that right. th
> e valves are adjusted to spec.
> the distributor is in time, c
> oil works, spark at plugs(new
> plugs), compression is at a ev
> en 120 psi on all cylinders. I
> s this Low, I have a book that
> says 160 psi? the engine fire
> s and acts like it will start
> but then it dies. Any help wou
> ld be very much appreciated as
> i have worked on this problem
> for over 2 weeks.
> Thanks, Chris.

Replys:

Re: engine will not start 22r-ec engine - chris 08/29/03 (0)
Re: engine will not start 22r-ec engine - Joshua S 08/28/03 (1)

Re: engine will not start 22r-ec engine - chris 08/29/03 (0)

Post a Reply:

Name:
Email:
Subject:
Message:	buz wrote: > not enuf compression > tell me you honed it > otherwise you'll haf to > unless you put the rings in wr > ong > > > chris wrote: > > > I have a 85 celica gts. We b > ou > > ght it for $200. they tried > to > > replace head gasket but did > i > > t wrong. I have gone through > a > > nd re done the head gasket. > in > > the process i got the head r > e > > surfaced and a valve job. Wh > il > > e i was at it i replaced pis > to > > n rings and rod bearings. I > be > > lieve i did all that right. > th > > e valves are adjusted to spe > c. > > the distributor is in time, > c > > oil works, spark at plugs(ne > w > > plugs), compression is at a > ev > > en 120 psi on all cylinders. > I > > s this Low, I have a book th > at > > says 160 psi? the engine fir > e > > s and acts like it will star > t > > but then it dies. Any help w > ou > > ld be very much appreciated > as > > i have worked on this proble > m > > for over 2 weeks. > > Thanks, Chris.
	Please click submit only once

Note: For security reasons your IP will be logged!