This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: Looking 4 hood trim/molding
| Posted By: | jason |
| Posted On: | November 18, 2003 at 12:40 am GMST |
shifting through gears, clutch is fine.....no presure,not fully dis engaging,bleed the line, if not better ...its one of the two, chande both...you change the slave cylinder you will be changing the master cylinder....reason, difference in amount of froce being applied to the o-rings
Theresa wrote:
> Hello,
> Does anyone out there have any
> of the following trim/molding
> parts for 1990 Toyota Celica
> ST:
> -plastic trim that goes across
> the hood
> -passenger side trim that goes
> behind the headlight
> -radiator trim molding that go
> es from headlight to headlight
> between the hood and the bump
> er
> -trim molding that goes along
> the top of the passenger side
> headlight assembly
> These are hard parts to find w
> ithout going to the dealership
> . Any help would be appreciat
> ed.
> Thanks!
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2003 Steven Benner. All rights reserved.
Last Modified: Wednesday, March 19, 2003 9:00 AM