This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: Has anyone had problems buying cheap break pads..
Posted By: Doug Cotter Posted On: July 31, 2002 at 8:24 pm EDT
Hi, sounds like you might have seized calipers or mounting hardware. Check it out, you might want to put a set of calipers on it. Also watch out for warping your front rotors with that heat.
Its worth a thought,
Good Luck.
StinkyFatPig wrote:
> I changed my breaks about 2 we
> eks ago... anyway, I ended up
> having tons of problems with m
> y master cylinder.. Not becaus
> e of my break job, it just hap
> pened.. ended up replaceing my
> master twice and my break boo
> ster.. I was having problems w
> ith my breaks locking.. after
> getting it all working, my cal
> ipers still seem to be getting
> kinda hot.. So, I was thinkin
> g, that maybe because of when
> i did my breaks, I was kinda b
> roke and went for the chepo pa
> ds.. (pads for an 83 are expen
> cive!!) after all that, my que
> stion is, has anyone had any p
> roblems with cheap pads? like
> them sticking, or possibly get
> ting to hot.. maybe wearing ex
> treamly un even... thanks
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2002 Steven Benner. All rights reserved.
Last Modified: Wednesday, July 17, 2002 2:38 AM