This is an archived message.
The reply function is disabled.
[ Message Forum | Thread Index | Post a Reply ]
Re: valve lash??
Posted By: Steven Benner Posted On: August 02, 2002 at 07:28 am GMDT
It is very important to have the valve lash set correctly. Both for performance and engine life.
If the valve is set to tight it wont close properly. That will allow combustion gasses to escape. If it is set too loose then it won't open far enough.
The best advice is to just keep the lash set to the specs in your manual.
- Steve
Replys:
Note: For security reasons your IP will be logged!
Copyright © 2001 - 2002 Steven Benner. All rights reserved.
Last Modified: Wednesday, July 17, 2002 2:38 AM