Welcome, Guest

Author Topic: RA64 Gas lid locking pin  (Read 82 times)

Offline 2468wdwa1

  • Newbie
  • *
  • Posts: 16
    • View Profile
RA64 Gas lid locking pin
« on: Jan 03, 2023, 09:20:14 pm »
I made a model of the locking pin for the gas lid for 3d printing since mine was broken when I got my car. You should sand the sides of the cylinder down a bit, and don't use any grease on the pin itself, I tested one with grease and no sanding and it seized up after about a week. Hope this helps!